Sharpvision XV-Z7000U - Manual (Page 32)

E-32
Useful Features
This function allows you to check the current input signal
information and the accumulated lamp usage time.
1 Press MENU.
2 Press ∂/ƒ to select “Options”, and then press
ENTER. The current input signal information and
the lamp usage time will be displayed.
• It is recommended that the lamp be replaced after
approximately 900 hours of usage. See pages 38 and 39
for lamp replacement.
Checking the Input Signal and the Lamp Usage Time
(GUI) On-screen Display
When no input signal is detected for more than 15
minutes, the projector will automatically shut off.
Description of Automatic Power Shutoff
1 Press MENU.
2 Press ∂/ƒ to select “Options”, and then press
ENTER.
3 Press ∂/ƒ to select “Auto Power Off”, and then
press ENTER.
4 Press ∂/ƒ to select “ON” or “OFF”.
5 To exit from the GUI, press MENU.
• “Auto Power Off” is factory preset to “ON”.
• “Power OFF in 5 min.” will appear five minutes before the
power is automatically turned off.
Automatic Power Shutoff Function
(GUI) On-screen Display
Projector Remote control
Projector Remote control
Power automatically shuts off after 15 minutes without
a signal being input.
Automatic Power Shutoff disabled.
ON
OFF
ON/OFF
POWER
LAMP
TEMP.
KEYSTONE
INPUT
BACK ENTER MENU
PICT MODE
VOL
POWER
MUTE
BACK
MENU
ENTER
2
2
1
ON/OFF
POWER
LAMP
TEMP.
KEYSTONE
INPUT
BACK ENTER MENU
PICT MODE
VOL
POWER
MUTE
BACK
MENU
ENTER
2, 3, 4
2, 3
1, 5