Sharpvision XV-Z7000U - Manual (Page 39)

E-39
Maintenance & Tr
oubleshooting
Replacing the Projection Lamp
7 Remove the lamp cage cover.
Turn over the projector and loosen the user service
screw that secures the lamp cage cover. Then lift
open the cover in the direction of the arrow.
9 10 Insert the new lamp cage. Attach the lamp cage cover.
Slide the lamp cage cover in the direction of the
arrow. Then tighten the user service screw. Press the lamp cage firmly into the lamp cage
compartment. Fasten the securing screws.
8 Remove the lamp cage.
Loosen the securing screws on the lamp cage.
Hold the lamp cage by the handle and pull it
towards you.
1 Connect the power
cord. Reset the lamp timer.
Plug the power cord into the AC
socket of the projector.
Resetting the lamp timer
2
• Reset the lamp timer only after replacing the lamp.
1 Press KEYSTONE ∂ and
KEYSTONE ƒ on the projector at
the same time.
2 Press INPUT and PICT MODE on
the projector at the same time.
3 Press PICT MODE and MENU on
the projector at the same time.
“LAMP 0000H” is
displayed, indicating that
the lamp timer is reset.
INPUT
BACK ENTER MENU
PICT MODE
1
3 2
Then Change Lamp (Steps 7-10)