Sony IPELA SNC-RZ25P - Manual (Page 71)

Ot
her
s
Using the SNC panorama creator — Creating a Panorama Image
71
Information boxes on the selected file are displayed
on the left side of the window as follows:
Each click on the
(information) icon switches
between “display” and “Not to display” of the file
information.
Model name: Model name of the camera with
which the file is recorded.
IP address: IP address of the camera with which
the file is recorded.
Serial number: Serial number of the camera with
which the file is recorded.
Record event: Type of event used for the
recording: Sensor input, Periodical, Motion
detection or Manual.
Date&time: Recording date and time
Movie: Video CODEC
Audio: Audio CODEC
Playing a video/audio file
Click (start) to start playing from the beginning of
the selected file.
To freeze the movie temporarily, click
(pause).
Click again to restart playing.
To stop playing, click (stop).
To restart playing, click (start) again.
Play stops when the file is played to the end.
To play from a specified point
Move the slider bar below the image display, and the file
will play starts according to the position of the slider bar.
Adjusting the sound
Adjust the playing sound volume by moving the
slider bar. Move it to the left end for the
minimum volume, and to the right end for the maximum
volume.
Click the speaker icon to enable/disable the sound
muting.
When the sound muting is on, no sound is heard even if
you move the slider bar to the right.
Saving an image
Click (capture) icon during playing or pause and the
captured image is displayed on a pop-up dialog. To save
the image, click Save on the dialog. You can specify the
destination to which the image is to be stored and select
the JPEG or Bitmap format.
Using the SNC
panorama creator
—
Creating a Panorama Image
The supplied SNC panorama creator allows you to
create a panorama image to be displayed on the main
viewer.
Using the panorama image, you can move the camera to
the desired position simply by clicking on the image.
This section explains the setup and operations of the
SNC panorama creator.
Installing the SNC panorama
creator
1
Insert the supplied CD-ROM disc into your
computer CD-ROM drive.
After a short time a window will open displaying
the files on the CD-ROM.
2
Click the Setup icon of SNC panorama creator.
The “File Download” dialog opens.
3
Click Open.
Note
If you click “Save this program to disk” on the “File
Download” dialog, you cannot install correctly.
Delete the downloaded file, and click the Setup icon
again.
4
Install the SNC panorama creator following the
wizard displayed.
If the Software License Agreement is displayed,
read it carefully and accept the agreement to
continue installation.
Using the SNC panorama creator
When you start the SNC panorama creator, the
following window is displayed.
The window consists of a main section to create a
panorama image and a setting section to prepare for
connection to the camera.