Sony IPELA SNC-RZ25P - Manual (Page 72)

Ot
her
s
Using the SNC panorama creator — Creating a Panorama Image
72
The created panorama image is displayed in the upper
viewer.
Angle setting
Set the view angle within the created 360-degree
panorama image.
Select the angle (degrees) from among “90,” “180,”
“270” or “360.”
If you want to limit the camera movement to the selected
view angle, check the “Lock” check box. The camera
moves only within the selected panorama view angle.
Note
The edges of the panorama image may not be displayed
correctly when the camera is zoomed in.
Make: Starts shooting for creating a panorama image (a
complete 360-degree panorama image). It takes
about two minutes to create a complete panorama
image.
Note
The exposure and white balance settings are fixed
while a panorama image is being created. To create
a clear panorama image, set Exposure mode to
Full auto and White balance to Auto in the
Camera setting menu and point the camera to the
main subject before starting shooting.
File-open: Allows use of a Bitmap or JPEG image file
in spite of a panorama image.
Note
The size of the image in the file should be 320 × 90
pixels (horizontal/vertical). Other image sizes are
not supported.
Send: Transmits a panorama image converted into a
JPEG file to the camera.
Administrator name: Type the ID of the administrator
of the camera.
Administrator password: Type the password of the
administrator of the camera.
Camera address: Type the IP address or host name of
the camera.
Camera port No.: Type the port number of the camera.
Use proxy: Check this item when you use a proxy
server.
Proxy server name: Type the IP address or host name
of the proxy server.
Proxy server port No.: Type the port number of the
proxy server.
Preparing connection to the camera
Before creating a panorama image, set the following
items in the Setting section to allow connection to the
camera.
Administrator name: Type the ID of the administrator
of the camera to be connected.
Administrator password: Type the password of the
administrator of the camera to be connected.
Note
The default settings of both items are “admin.”
Camera address: Type the IP address or host name of
the camera to be connected.
Camera port No.: Type the port number of the camera
to be connected.
When you use a proxy server for camera connection,
check the Use proxy check box and set the following
items.
Proxy server address: Type the IP address or host name
of the proxy server.
Proxy server port No.: Type the port number of the
proxy server.
Preparations for connecting to the camera are now
completed.