Sony VMC-IL4415 - Manual (Page 68)

Other Information
62
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to
control with the DTV’s remote control, use the following procedures
to program the remote control.
1 Check the list of the “Manufacturer’s Codes” listed on page 64,
and find the three-digit code number for the manufacturer for
your equipment. (If more than one code number is listed, start
with the number listed first.)
2 Open the lid on the remote control. Then move the slide switch to
one of the four positions (AV1, AV2, AV3, DVD).
3 Press CODE SET .
4 Close the lid on the remote control and enter the three-digit
manufacturer’s code number.
5 Press ENTER .
6 To check if the code number works, aim the DTV’s remote control
at the equipment and press the green
POWER button that
corresponds with that equipment. If it responds, you are done. If
not, try using another code listed for that manufacturer.
Sony
Equipment Switch Position
on Remote Control Programmable
Code Number
Beta, ED Beta VCRs AV1 303
8 mm VCR AV2 302
VHS VCR AV3 301
DVD Player DVD 751
✍
The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
✍
You must perform step 4 within 10 seconds of step 3.
3
2
5
4