Samsung WF-J1254 - Manual (Page 10)

10_ Installing the washing machine
CONNECTING THE WATER SUPPLY HOSE
The water supply hose must be connected to the washing machine at one end and to the water faucet at
the other. Do not stretch the water supply hose. If the hose is too short and you do not wish to move the
washer, replace the hose with a longer, high pressure one.
To connect the water supply hose:
1. Take the L-shaped arm fitting for the water supply
hoses and connect to the water supply intake on the
back of the washer.
Tighten by hand.
2. Connect the other end of the cold water supply hose
to your sink’s cold water faucet and tighten it by hand.
If necessary, you can reposition the water supply hose
at the washing machine end by loosening the fitting,
rotating the hose, and retightening the fitting.
Optional:
1. Take the red L-shaped arm fitting for the hot water supply hose and connect to the red hot
water supply intake on the back of the machine. Tighten by hand.
2. Connect the other end of the hot water supply hose to your sink’s hot water faucet and tighten it by hand.
3. Use a Y-piece if you only want to use cold water.
The washer should be connected to the water faucets using new hose-sets.
Old hose-sets should not be used.
POSITIONING THE DRAIN HOSE
The end of the drain hose may be positioned in three ways:
Over the edge of a sink
The drain hose must be placed at a height between 24
and 35 inches. To keep the drain hose spout bent, use the
supplied plastic hose guide. Secure the hose guide to a
wall with a hook or to the faucet with a piece of string to
prevent the drain hose from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 24 inches
above the ground.
ln a drain pipe
Samsung recommends that you use a 26 inch high vertical pipe; it must be no shorter than 24 inches
and no longer than 35 inches.
installing the washing machine