Samsung WF-J1254 - Manual (Page 14)

14_ Washing a load of laundry
WASHING CLOTHES MANUALLY
You can wash clothes manually without using the “Fuzzy Logic” feature.
To do so:
1. Turn on your sink’s water faucet.
2. Press the POWER button on the washing machine.
3. Open the door.
4. Load the articles one at a time loosely into the drum, without overfilling.
5. Close the door.
6. Put the detergent and, if necessary, softener or chlorine bleach, in the appropriate
compartments.
7. Press the Temp. button to select the water temperature.
(Hot/Warm  Hot/Cold  Warm/Warm  Warm/Cold  Cold/Cold )
8. Press the Soil Level button to select the soil level for the load.
(Very Heavy  Heavy  Normal  Light  Very Light)
9. Press the Spin button to select the spin speed, [Extra high  High  Medium  Low  No
Spin  Rinse Hold].
The rinse hold program allows you to take clothes that are dripping wet out of the washing
machine.
no : No Spin, rh : Rinse Hold.
10. Press the button repeatedly to cycle through the available delayed start options (from 2 to
24 hours in one hour increments).The displayed hours indicate when the washing cycle will
finish.
11. Press the Start/Pause button and the machine will begin the cycle.
When the cycle is finished:
1. Open the door.
The door will not open until 3 minutes after the machine stops or the power turns off.
2. Remove laundry.
USING DELAY START
You can set the washing machine to finish your wash automatically at a later time, choosing from 2 to 24
hour delay (in 1 hour increments). The displayed hours indicate when the washing cycle will finish.
To do so:
1. Manually or automatically set your washing machine for the type of clothes you are washing.
2. Press the Delay Start button repeatedly until the delay time is set.
3. Press the Start/Pause button. The Delay Start indicator will light, and the clock will begin
counting down until the washing cycle finished.
4. To cancel “Delay Start”, press the POWER button, then turn the washing machine on again.
washing a load of laundry