Samsung WF-J1254 - Manual (Page 9)

Installing the washing machine _9
SELECTING A LOCATION
Before you install the washing machine, select a location with the following characteristics:
• A hard, level surface (if the surface is uneven, see “Adjusting the leveling feet,” below)
• Away from direct sunlight.
• Adequate ventilation
• Room temperature that will not fall below 32 ˚F
• Away from sources of heat such as coal or gas
Make sure that the washing machine does not rest on its power cord.
Ventilation openings must not be obstructed by carpeting when the washing machine is installed
on a carpeted floor.
THE MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS - SIDES 0 IN.,
REAR 1 IN. TOP 2 IN., CLOSET FRONT 0 IN.
Closet Front Must Have Two Unobstructed Air Openings Combined Total Area 72 Sq. In. Min.
Located 3 in. From Top and Bottom. Louvered Door With Equivalent Air Opening Is Acceptable.
ADJUSTING THE LEVELING FEET
If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the
feet):
1. Loosen the leg bolt by turning it with your hand
until it is at the desired height.
2. Tighten the locking nut by turning it with the
supplied wrench.
• Place the washer on a sturdy, flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration occurs.
(Only a l degree angle is allowed.)
REMOVING THE SHIPPING BOLTS
Before using the washing machine, you must remove all of the shipping bolts from the back of
the unit.
To remove the bolts:
1. Loosen all bolts with the supplied wrench before
removing them.
2. Take each bolt head and plastic together, pull it
through the wide part of the hole.
Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the transit bolts for future use.
01
INST
ALLING THE W
ASHING MACHINE
oC rpm Min
Fuzzy control
Temp Spin Delay Start Function Door open
Power Spin Check
Remaining Time
Delay Start
Rinse Wash Pre-wash
Eco Speedy
Wool Delicate Synthetic Cotton
START PAUSE
12:00