Sony DS-2 - Manual (Page 59)

59
9
T
roubleshooting
Troubleshooting
Symptom
Nothing appears
on the display
Won’t start
Unable to
record
No playback
tone heard
Does not
reverse skip in
the set skip
interval
Unable to erase
Noise heard
during playback
Recording level
too low
Unable to set
index marks
Probable cause
The batteries are not loaded properly.
The batteries are dead.
The recorder is in HOLD mode.
The recorder is in HOLD mode.
The batteries are dead.
Low remaining internal memory.
The maximum number of files has been
reached.
The earphone is connected.
The VOL button is set to 0.
The auto backspace review is set to “1
SEC SKIP” or “2 SEC SKIP”.
The file is locked.
The recorder was shaken during
recording.
The recorder was placed near a cell
phone or fluorescent lamp while
recording or during playback.
The microphone sensitivity is too low.
The maximum number of index marks
(16) has been reached.
The file is locked.
Action
Verify polarity is correct.
Replace with new batteries ( ☞ P.11).
Release the recorder from HOLD
(
☞ P.12).
Release the recorder from HOLD
(
☞ P.12).
Replace with new batteries ( ☞ P.11).
Erase unnecessary files ( ☞ P31).
Check another folder.
Unplug the earphones to use the internal
speaker.
Adjust the VOL button.
Set the auto backspace review to “OFF”
in the menu setting.
Unlock the file.
Move the recorder.
Set the microphone sensitivity to
CONFERENCE mode and try again
(
☞ P.22).
Erase unnecessary index marks
(
☞ P.35).
Unlock the file.