Samsung SSA-P102T - Manual (Page 7)

English _ 7
PRODUCT INTRODUCTION
Main Board
1 Fixing Hole
Used to attach SSA-P102 to the closure using a metal supporter. (Ensure that you use
the metal supporter to prevent the EMI.)
2 2Pin DIP Switch Used to set the type of a connected reader to either 26bit Wiegand or 34bit Wiegand.
3 8Pin DIP Switch
The device address and communication speed specifi ed by the applicable switch should
be consistent with those of the computer that is used for communications.
(Address Setting: Pin 1 to Pin 5 of the DIP Switch, Communication Speed: Pin 6 to Pin 8
of the DIP Switch)
4 System Initialize Switch
Pressing both of the switches at the same time for about 2 seconds will sound
initialization ready beep. Releasing both switches will stop the beep, and restarts the
system after the initialization.
5 RJ-45 Connect the LAN cable for TCP/IP communications.
6 LED Indicates the state of the LAN communications.
7 RL#1, RL#2
Ports where the buzzer control line or the LED control line of the reader is connected to
display the operation status of Relay 1 or Relay 2.
8 Input #5 Input Port: The fl ashing LED indicator denotes that a signal is sensed by the port.
9 Input #4 Input Port: The fl ashing LED indicator denotes that a signal is sensed by the port.
1
13
30
7
8
9
10
11
12
15
18
16
19 27 28 29
14
20
21
22
23
24
17
25
26
2 3 4 5 6