State Industries ULTRA FORCE 101 - Manual (Page 56)

56
lighting the water heater
OFF
REG
ADJUST
ON
F L O W
FOR YOUR SAFETY READ BEFORE OPERATING
TO TURN OFF GAS TO APPLIANCE
OPERATING INSTRUCTIONS
Wait five (5) minutes to clear out any gas. If you then
smell gas, STOP! Follow “B” in the safety information
above on this label. If you don’t smell gas, go on to
the next step.
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
A.
B.
1.
2.
C.
D.
•
•
•
This appliance does not have a pilot. It is equipped with
an ignition device which automatically lights the burner.
Do not try to light the burner by hand.
STOP! Read the safety information above on this
label.
Do not try to light any appliance.
Do not touch any electrical switch; do not use any telephone
in your building.
Immediately call your gas supplier from a neighbor’s
•
telephone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire
department.
Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it, call a qualified service
technician. Force or attempted repair may result in fire
or explosion.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
BEFORE OPERATING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
Set thermostat to lowest setting.
1. Set the thermostat to lowest setting.
8. Set thermostat to desired setting.
9. If the appliance will not operate, follow the instructions
“To Turn Off Gas To Appliance” and call your service
technician or gas supplier.
3. Turn off all electrical power to the appliance.
2. Turn off all electrical power to the appliance if service is to be performed.
7. Turn on all electrical power to the appliance.
6.
3. MOve “Off/On” switch to the “Off” position. Do not force.
4. This appliance is equipped with an ignition device which
automatically lights the burner. Do not try to light the
burner by hand.
5. Move “Off/On” switch to the “Off” position.
Move “Off/On” switch to the “On” position.
“WHAT TO DO IF YOU SMELL GAS”
WARNING
On/Off Switch
lighting & operation labels
The instruction label below is affixed to the water heater's covered by this manual at the factory and must be followed when lighting
and operating the water heater.
suf 60 120 and suf 100 150 models only