Samsung C4235(P) - Manual (Page 32)

2
FLICKERLESS
When this is set to [ON], the shutter speed is set to 1/100 sec (for
NTSC) or 1/120 sec (for PAL) to prevent from flickering by the
discordance between vertical synchronization frequency and
on-and-off frequency of the light.
REVERSE
It is used to mirror video signals horizontally, vertically, or both.
DETAIL
It is used to control the horizontal or vertical distinction.
Y-LEVEL
It is used to set the levels for the Sync signal and the entire brightness
signal of the video signal.
C-LEVEL
It is used to set the levels for the Burst signal and the entire colour
signal of the video signal.
POSI/NEGA
It is used to output as it is, or mirror the video brightness signal.
RS-5
If you press the SETUP switch when [...] is selected in the [RS-485]
menu, the corresponding screen appears.
You can set the PROTOCOL, BAUD RATE, and ADDRESS (range: 0
to 255) for this communication.
(SPECIAL)
LANGUAGE.. ENGLISH
VIDEO.SET. ...
RS-485. . ...
ZOOM.SPEED.. 4
DIGITAL.ZOOM.. OFF
DISPLAY.ZOOM.. OFF
SYSTEM.INFO.. ...
CTRL.TYPE.. A
V-SYNC.. INT
RET
(RS-485)
PROTOCOL. . SAMSUNG
BAUD.RATE.. 9600
ADDRESS.. 0
RET
SCC-C4333_Eng-EURO.indd 32 2007-11-12 오전 10:18:28