Smarthome 7307 - Manual (Page 5)

4. Attach the unit to the wall. If hanging the
unit, insert two screws using the template
provided. If screwing the back directly to
the wall, take the back plate right off by
prying apart one hinge. Use as much
force as needed. The plastic hinge will not
break.
5. Using the template, attach the backplate
on to the wall with 4 screws.
6. Mount the Control Panel on the backplate.
Insert one hinge into the hole, then twist
the other hinge into position.
7. Firmly close the case.
8. Plug the AC adapter into a power outlet.
The red AC PWR light and keypad back-
light will be on.
INSTALLING THE DOOR/WINDOW SENSOR (WT-433)
It is recommended to install one sensor on your front door and the other on
your back door.
Each contact sensor has 4 parts:
INSTALLATION
Transmitter Magnetic Switch Magnet Spacers
1. Position the transmitter be-
side the door/window frame on
the wall using either two sided
tape or screws. If you are using
screws, first pry off the back plate
with a small screwdriver and
screw the back plate into posi-
tion using the template. Then click
the transmitter on to the back
plate now mounted on the wall.
– 9 –
INSTALLATION
2. Position the magnetic switch connected to
the transmitter on the door/window frame.
3. Position the magnet on the door beside the
magnetic switch. They should be no more
than 1 cm (3/8 inch) apart. When the door/
window is closed, the magnets are in contact.
When the door/window is opened, contact is
broken and the transmitter sends a signal to
the Control Panel to activate the chime or
alarm.
INSTALLING THE MOTION SENSOR (PS-433)
The motion sensor senses motion from up to
13 meters, (40 feet) away in a 110 degree arc.
It works best when installed from 2 meters,
(approx. 7 feet) off the ground in a corner.
Please position the sensor so that it is looking
down at an angle of about 12 degrees.
We recommend that you position the motion
sensor where it will guard the bedrooms. For
example, have your motion sensor monitoring
the stairway which leads to all the bedrooms
upstairs. A hallway or central area can also be
used.
1. Once you have decided on a location, tape
the template into position. If you are putting
the motion sensor in a corner, first fold the
template along the center line so it will fit
snugly into the angle. Screw the two mount-
ing screws in position, (if installing on a flat
wall, use the screw holes one above the other,
if installing in a corner, use the screw holes
on sides of the unit).
2. Insert the 9 volt alkaline battery.
(original battery inserted by factory)
3. Match up the two screws with the appropriate
two keyholes on the back of the Motion Sensor,
then hang the unit in position.
– 8 –
SMARTHOME.COM™ 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com Order #7307