Assembly instructions – Stamina Products 55-1537C User Manual
Page 9
STEP 7:
Attach the
FOOTREST(11)
onto the
HEIGHT ADJUSTMENT BEAM(10)
with the adjustment
holes facing down. Secure the
FOOTREST(11)
in place with the
ADJUSTMENT KNOB(12).
NOTE:
ASSEMBLY INSTRUCTIONS
9
The four adjustment holes in the
FOOTREST(11)
allow the
FOOTREST(11)
to be attached in
four different positions. Start with one of the center positions and adjust if necessary. Use the outer
position if users are taller than average. Use the inner position if users are shorter than average.
STEP 8
Insert the
HEEL HOLDER TUBE(13)
through the hole on the
HEIGHT ADJUSTMENT BEAM(10)
and secure with
BOLT(M6 x 47mm)(60), WASHERS(M6 x ø16 x 1.5mm Thick)(68),
and
NYLOCK
NUT(M6)(66).
Place a
HEEL HOLDER BRACKET(14)
onto a
HEEL HOLDER(15),
then slide them
onto the
HEEL HOLDER TUBE(13)
together. Repeat on other side.
STEP 9
Insert the
OUTER PAD TUBE(17)
through the hole on the
HEIGHT ADJUSTMENT BEAM(10).
Insert
the
INNER PAD TUBE(16)
into the
OUTER PAD TUBE(17).
Align the holes on the
INNER PAD
TUBE(16),
OUTER PAD TUBE(17)
, and
HEIGHT ADJUSTMENT BEAM(10),
then bolt them together
with
BOLT(M6 x 35mm)(59)
and
ARC WASHER(M6)(71).
WARNING:
The
PAD TUBES(16, 17)
must be assembled with the ends pointed downward as shown.
The ends must be pointed downward to properly secure the users feet in place during inversion.
Improper assembly will allow the user's feet to come loose and the user will fall from the
Elite
Inversion System.