Sony TC-TX313 - Manual (Page 12)

Sony Corporation Printed in China
Specifications
Recording system 4-track 2-channel stereo
Frequency response (DOLBY NR OFF)
50 – 14,000 Hz ( ±3 dB),
using Sony TYPE I
cassettes
50 – 15,000 Hz ( ±3 dB),
using Sony TYPE II
cassettes
Wow and flutter ±0.13% W. Peak (IEC)
0.07% W. RMS (NAB)
±0.2% W. Peak (DIN)
Input TAPE IN (phono jacks):
impedance 47 kilohms
Output TAPE OUT (phono jacks):
voltage 550 mV
impedance 47 kilohms
General
Power requirements
North American model:
110 V AC, 50/60 Hz
European countries model:
220 – 230 V AC, 50/60 Hz
Other models: 110 – 120 V or 220 – 240 V
AC, 50/60 Hz
Adjustable with the
voltage selector
Power consumption 12 W
Dimensions Approx. 215
Ч
60
Ч
230
mm (w/h/d)
incl. projecting parts and
controls
Mass Approx. 2.5 kg
Supplied accessories: Audio connecting cords
(2)
Design and specifications are subject to change
without notice.
Noise increases or the high frequencies
are erased.
•The record/playback heads are
magnetised. Demagnetise them (see
page 11).
•Move the tape deck away from the TV or
VCR.
The sound is distorted.
•Set DOLBY NR to the same setting in
which the tape was recorded.
•Move the tape deck away from the TV or
VCR.
There is no sound.
•The mains lead is disconnected from the
mains.
•Make sure the audio connecting cords
are connected correctly (see page 5).
The remote supplied with the DHC-MD313
does not function.
•Press FUNCTION on the DHC-MD313 to
switch the FUNCTION to “TAPE.”
•Make sure the AU BUS connecting cord
is connected correctly (see page 4).
Automatic Source Selection or One Touch
Play does not work.
•Make sure the AU BUS connecting cord
is connected correctly (see page 4).
The functions tied with the
DHC-MD313, such as CD Synchro
Recording, do not work.
•Make sure the AU BUS connecting cord
is connected correctly (see page 4).
The inserted tape will not eject.
•The POWER of the tape deck is OFF.
Press POWER to turn on the tape deck,
then press
§.
The cassette indicator flashes.
•Press POWER to turn off the tape deck,
then press POWER again to turn on the
tape deck.
Troubleshooting (continued)