Sharp PG-MB60X - Manual (Page 57)

-53
Useful Features
Note
• If you input a wrong keycode, the cursor returns
to the first point of the “Old Code”.
• The preset keycode is 4 " buttons on the projec-
tor. If this keycode is set, the keycode input screen
does not appear when turning the power on.
3
Press the 4 buttons on the remote
control or on the projector to enter
the new keycode in “New Code”.
Note
• You cannot use the following buttons for
keycode:
• ON button
• STANDBY button
• L-CLICK/ENTER button
• R-CLICK/UNDO button
• MENU button
• ZOOM/FOCUS button
• ZOOM buttons
• FOCUS buttons
• System Lock function recognizes each but-
ton on the remote control or on the projec-
tor as an individual button, even if they share
the same button name. If you set the keycode
with the buttons on the projector, use only
those buttons on the projector. If you set the
keycode with the buttons on the remote con-
trol, use only those buttons on the remote
control.
4
Enter the same keycode in
“Reconfirm”.
Note
Not displaying the keycode input screen
when turning the projector on
• Press " on the projector for four times in steps
2 and 3 above.
When the System Lock is set
• When System Lock is set, the keycode input
screen appears after the power is turned on.
When it appears, enter the right keycode to start
projection. Failure to enter the keycode will
cause images not to be projected even when
signals are entered to the projector.
System Lock Function
This function prevents unauthorized use of the pro-
jector. Once this function is activated, users must enter
the correct keycode each time the projector is turned
on. We suggest you record the keycode in a safe place
where only authorized users have access.
Info
• If you lose or forget your keycode, contact your
nearest Sharp Authorized Projector Dealer or Ser-
vice Center (see page
70 ). Even if the product war-
ranty is valid, the keycode reset will incur a charge.
Menu operation Page 42
Example: “Options1” screen menu for
INPUT 1 (RGB) mode
Setting the keycode
1
Select “System Lock” on the “Op-
tions1” menu, then press .
• A message is displayed.
• Read this message, and press
.
2
Press the 4 buttons on the remote
control or on the projector to enter
the preset keycode in “Old Code”.
• When setting the keycode for the first time,
press " on the projector for four times.
" " " " " On-screen Display