Sharp PG-MB60X - Manual (Page 62)

-58
Selecting the Transmis-
sion Speed (RS-232C)
Make sure that both the projector and computer
are set for the same baud rate.
Menu operation Page 42
Example: “Options2” screen menu
Description of RS-232C
Note
• Refer to the “SETUP GUIDE” contained on the
supplied CD-ROM for RS-232C Specifications
and Command Settings.
• Refer to the computer’s operation manual for
instructions for setting the computer’s baud rate.
Description
Transmission speed is slow.
Transmission speed is rapid.
Selectable items
9600 bps
115200 bps
Monitor Output Settings
When the Monitor Out has been set to “Enable”,
the monitor output is activated and power is con-
sumed even in the standby mode. It is recom-
mended that the Monitor Out be set to “Disable”
when it is not connected. This reduces power
consumption when the projector is in the standby
mode.
Menu operation Page 42
Example: “Options2” screen menu
Description of Monitor Out
Description
The monitor output function is activated
even if the projector is in standby mode.
The monitor output function is switched off
when the projector is in standby mode.
Selectable items
Enable
Disable
Helpful Functions Set during Installation (“Options2” menu)