Samsung Color Dual Quad Network Observation System SSC21WEB - Manual (Page 26)

Eng-26
3-2) DATE/TIME MENU Function setting
• Function: Sets the display date format and current time.
• Setting method: Move to #2. DATE/TIME MENU by using œ œENTER√ √ SWITCH at setup menu,
then press the ENTER SWITCH to display the OSD as shown in the below figure. (The figure
shows the initial setting status.)
• Setting method of date display format
Move to the format item by turning œ œENTER√ √ SWITCH, and enter the mode for setting date
format by pressing the ENTER SWITCH.
At this time, select a target date format by turning left and right the SWITCH.
(“YY/MM/DD”, “MM/DD/YY”, “DD/MM/YY” are available for selectable data format.)
• Date and current time setting method
Repeat the above instruction for moving to each item (MONTH, DAY, YEAR, HOUR, MINUTE,
SECOND) and entering the mode. Current date and time to display can be set. (It can be referred
when ALARM or LOSS occurs.)
3-3) DWELL TIME MENU function setting
• Function: Displays each picture for pre-set time and automatically switches it to the next picture
at SEQUENTIAL DISPLAY MODE.
• Setting method: Move to #3. DWELL TIME menu by using œ œENTER√ √ SWITCH at SETUP
MENU, and press the ENTER SWITCH to display the following OSD as shown in the below
figure. (The figure shows the initial setting status.)
06/01/03 13:14:00
DATE TYPE MM/DD/YY
DATE 06 / 01 / 03
TIME [HH:MM:SS] 13 : 14 : 00
DATE/TIME SETTING
06/01/03 13:14:00
CAM1 03 SEC
CAM2 03 SEC
CAM3 03 SEC
CAM4 03 SEC
CAM5 03 SEC
CAM6 03 SEC
CAM7 03 SEC
CAM8 03 SEC
QUAD-A 03 SEC
QUAD-B 03 SEC
DWELL TIME SETTING
SSC21WEB-1 2004.8.25 5:38 PM Page 26