Silicon Laboratories Network Card - Manual (Page 10)

E t h e r n e t - D K
10 Rev. 0.6
5. In the System Settings section of the left window, select IP Addresses.
6. In the right window, set the Source IP Address to the IP address of the embedded system.
7. If the Gateway IP Address and Subnet mask of the network are known, then fill in the addresses on the
right window (see Figure 8).
8. If using the CP2200, the MAC address field is ignored. The CP2200 Ethernet Controller contains a unique
factory-programmed MAC address stored in Flash memory.
Figure 8. TCP/IP Configuration Wizard IP Address Specification