Silicon Laboratories Network Card - Manual (Page 23)

Ethernet-DK
Rev. 0.6 23
7. Enter the IP address, subnet mask, and default gateway (if known) into the ‘Assign IP Address’ dialog and
press OK. See Appendix A for information on how to configure the PC with a static IP address and how to
select a static IP address for the CP2201EB. A windows command line window should appear, ping the
device at its new address, then close. Programming is successful when the progress bar stops and gives the
message “Success - Device Programmed” as shown in Figure 18.
.
Figure 18. Assign IP Address Dialog
8. Close the ‘Assign IP Address’ dialog then press Search to refresh the Netfinder screen.
9. Select the device by clicking inside the yellow area and pressing the Web Browser quick launch button
as shown in Figure 19.
Figure 19. Web Browser Quick Launch Button In Static IP Address Mode