Sirius Satellite Radio SIRIUS STILETTO 2 Model SLV2 - Manual (Page 101)

98
Additional Information
tuck the cable inside it, then replace the weather stripping. To avoid sharp bends in the
cable, run the cable inside of the weather stripping for a few inches, then remove the
cable from the weather stripping inside of the trunk. Keep the cable away from hinges,
gears, etc., that could damage it.
Route the cable out from the rubber weather stripping and along the trunk wall.
Continue routing the cable into the cabin through a conduit or along an existing wiring
harness.
Route the cable through the main cabin area under the interior trim, towards the front
of the vehicle. Use the plastic putty knife to lift the plastic trim just enough to tuck
the cable under underneath. Avoid side airbag locations on back pillars and above the
doors. (Airbag locations are marked with “SRS” logos.) Be careful not to crimp or cut
the cable.
Bring the cable out from the trim near the firewall and route it under the carpet toward
the dashboard or console. Coil any excess cable in a hidden location, such as under the
carpet, keeping it away from any vehicle pedals or controls. Secure the excess cable
with wire ties.
Bring the end of the cable out at the SIRIUS radio location. Leave yourself enough
cable so you can easily connect it to the antenna connector of the SIRIUS radio or
vehicle dock.
3.
4.
5.
6.