Sanyo DIR-2000 - Manual (Page 17)

17
QuickTips
■ Pressing the CH Map
remote key will display
a blank page with cat-
egory tabs only, if
channel signals are
not detected.
■ When the CHannel
Map page is active,
only the Power, CH
Map, Tuner, Enter and
Cursor keys are
operational.
■ When the CHannel
Map page is active, the
TUNER key will switch
between the tuning
systems (DTV and
NTSC).
Need help?
Visit our Web site at
www.sanyoctv.com
Using the Channel Map
1. Press the CH MAP key on the remote control once to display the
CHannel Map page(s).
2. Use the / keys to highlight the desired category: DTV
or NTSC.
3. Press the CH MAP key to exit.
NOTE: Deleted channels will be blue. The current channel will
have a yellow background.
Figure 40—NTSC CH Map
To quickly select a channel within the CHannel Map page:
1. Press the CH MAP key on the remote control.
2. Use the / keys to highlight the desired category:
DTV or NTSC.
3. Use the CURSOR keys to highlight the desired channel. For
example, Channel 52. Press the ENTER key. (See Figure 42.)
To quickly switch between a DTV and NTSC channel:
1. Press the TUNER key repeatedly until the desired tuning system
channel number display appears on the screen.
2. Select an NTSC cable channel by entering the channel number.
For cable channels above 100 press and hold the 1 key for about
two seconds (until 1-- appears). Then enter the other two digits.
OR
3. Select a DTV channel by entering the major and minor numbers of
the channel as follows: 4, 3, (–) Sub, 0, and 5 for channel “D43-05.”
NOTES:
•
The CHannel Map shows all available channels and reflects the
current status of channels within the CHannel Scan Memory. All
deleted channels will appear blue.
• The tuner channel (DTV and NTSC) categories:
DTV (digital) channels with only major channel numbers listed.
NTSC (analog) channels with Cable channels 01~125 or
VHF/UHF channels 02-69.
•
Entering 00 for the minor channel number will cause the SDB to
tune to the NTSC channel matching the major channel number.
Express Channel Selection
Figure 42—NTSC Channel C52,
selected
Figure 41—Channel Map of NTSC
channels display