Seagate BARRACUDA 2LP ST31250W/WD/WC/DC - Manual (Page 40)

38 Barracuda 2LP Installation Guide, Rev. E
W/WD drives
Setting the SCSI ID jumpers
Use the J5 connector to set the SCSI ID (Figure 10). To
change the SCSI ID, install jumpers on the appropriate
pins as shown in the illustration.
DC Power
Connector
SCSI I/O
Connector
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
SCSI ID = 0 (default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
J5
4P 3P 2P 1P
Pin 1 Pin 1
ID3
ID2
ID1
ID0
J5
Figure 10. Setting the SCSI ID