Schumacher XP2260 - Manual (Page 4)

• 3 •
iNSTANT POWER™ LOCATiON 4.
RiSk OF EXPLOSiON ANd CONTACT WiTh
BATTERY ACid.
Locate the Instant Power™ as far away 4.1
from the battery as the DC cables permit.
Never place the Instant Power™ 4.2
directly above the battery being jumped; gases
from the battery will corrode and damage the Instant Power™.
Do not operate the Instant Power™ in a closed-in area or restrict the ventilation in any way.
4.3
dC CONNECTiON PRECAUTiONS 5.
Connect and disconnect the DC output clips only after setting all of the Instant Power™ 5.1
switches to the “off” position (if applicable) and removing the AC plug from the electrical
outlet. Never allow the clips to touch each other.
Attach the clips to the battery and chassis, as indicated in the operating instructions.
5.2
ChARGiNG ANd AC POWER CORd CONNECTiONS 6.
RiSk OF ELECTRiC ShOCk OR FiRE.
The Instant Power™ charger is for use on a nominal 6.1
120-volt circuit. The plug must be plugged into an outlet that
is properly installed and grounded in accordance with all local
codes and ordinances. The plug pins must fit the receptacle
(outlet). Do not use with an ungrounded system. NOTE:
Pursuant to Canadian Regulations, use of an adapter plug is not allowed in Canada. Use
of an adapter plug in the United States is not recommended and should not be used.
iNSTALLATiON iNSTRUCTiONS
7.
Remove all cord wraps and uncoil the cables prior to using the Instant Power™.
FEATURES
8.
1
2
3
4
5
6
7
8 9
10
11
12
13
14
15
17
19
16
Jump Start/USB On/Off Switch 1.
USB Port 2.
Built-In Work Light 3.
Digital Display 4.
Display Button 5.
Work Light On/Off Switch 6.
Inverter On/Off Switch 7.
12 Volt DC Outlets 8.
120 Volt AC Outlets 9.
Compressor Hose 10.
Compressor Gauge 11.
Compressor/Inflator Switch 12.
Inflator Port 13.
Charger Plug 14.
Wall Charger 15.
Battery Clamps 16.
Deflator Port 17.
Adapters 18.
Inflator Hose 19.
18