Schumacher XP2260 - Manual (Page 7)

• 6 •
The Instant Power™ light will turn on and illuminate your work area. 4.
Press the Light Switch to the OFF position. 5.
Charge the Instant Power™ as soon as possible after using the built-in light. 6.
Using the Air Compressor 10.6
RiSk OF EXPLOSiON.
Read the instructions of the product being inflated before using the compressor.
Avoid overinflation, do not exceed the manufacturer’s recommended pressures.
Do not leave the air compressor unattended during use.
Ensure the battery clips are securely on the storage holders. 1.
Remove the air compressor hose from the storage compartment in the back 2.
of the Instant Power™. Install adapters as necessary.
Attach the air compressor hose to the product or accessory to be inflated.
3.
Place the Compressor/Inflator Switch in the COMPRESSOR position and inflate 4.
the product.
When the product is inflated to the proper air pressure (using the air compressor
5.
gauge) place the Compressor/Inflator Switch in the OFF position and remove the hose.
Do not run for more than 10 minutes maximum at a time. Allow the Instant Power™
6.
to cool down for 10 minutes before using again.
NOTE: To prevent overheating, the compressor has built-in thermal protection that
will turn the compressor off before it overheats. If the compressor shuts off, wait a few
minutes and it will automatically restart when the compressor cools.
NOTE: The air compressor is rated for 150 PSI.
Using the Inflator
10.7
RiSk OF EXPLOSiON.
Read instructions of the product being inflated before using the inflator. Avoid
overinflation, do not exceed the manufacturer’s recommended pressures. Do
not leave the inflator unattended during use.
Ensure the battery clips are securely on the storage holders. 1.
Attach the corrugated hose with end adapter to the high-flow inflator outlet 2.
located near the Compressor/Inflator switch on the back of the Instant Power™.
The main accessory adapter attached to the corrugated hose accommodates up to 4
3.
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
Insert the adapter into the product to be inflated.
4.
Push the Compressor/Inflator switch to the INFLATOR position and inflate the product. 5.
When the product is inflated to the desired level, push the Compressor/Inflator switch 6.
to the OFF position and remove the adapter.
Using the Deflator 10.8
Ensure the battery clips are securely on the storage holders. 1.
Attach the corrugated hose with the end adapter to the high-flow deflator outlet, 2.
which is located on the side of the Instant Power™.
The main accessory adapter attached to the corrugated hose accommodates up to 4
3.
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
Insert the adapter into the item to be deflated.
4.
Push the Compressor/Inflator switch to the INFLATOR position and deflate the item. 5.
When the product is deflated to the desired level, push the Compressor/Inflator 6.
switch to the OFF position and remove the adapter.
Before Using the inverter 10.9
important Safety instructions:
Keep the Instant Power™ well ventilated in order to properly disperse heat generated 1.
while it is in use. Make sure there are several inches of clearance around the top and
sides, and do not block the vents on the back of the Instant Power™.