Smarthome NSTEON KEYPADLINK 2486D - Manual (Page 15)

INSTEON KeypadLinc V2 Dimmer User’s Guide
Configure For Six or Eight Button Operation
• KeypadLinc Dimmer defaults to operation in six button mode. If the eight button plate is attached
to KeypadLinc Dimmer, pull the SET button at the bottom of the switch all the way out, and wait
10 seconds. While simultaneously pressing the “A” button (upper left-most button) and “H” button
(lower right-most button), push the SET button back in to its normal position (do not press the
SET button all the way in, rather let it return to its normal position). KeypadLinc Dimmer is now
operating in eight button mode.
• If KeypadLinc Dimmer is to be changed from eight button to six button configuration, replace the
eight button plate with the six button plate. Pull the SET button at the bottom of the switch all the
way out, and wait 10 seconds. While simultaneously pressing the ON and OFF buttons, push the
SET button back in to its normal position (do not press the SET button all the way in, rather let it
return to its normal position). KeypadLinc Dimmer is now operating in six button mode.
NOTE
The KeypadLinc Dimmer programming instructions in this manual often require pressing the ON
button as part of the process. If installed with the eight button insert, press the “A” button (the
upper left-most button) when instructions call for pressing the ON button.
Page 15 of 38