Smarthome NSTEON KEYPADLINK 2486D - Manual (Page 19)

INSTEON KeypadLinc V2 Dimmer User’s Guide
Unlinking KeypadLinc Dimmer from an INSTEON Controller
If you are no longer going to control a KeypadLinc Dimmer with an INSTEON Controller, it is very
important that you unlink it, because otherwise the controller will retry any commands intended for the
unused KeypadLinc Dimmer, thus slowing down your system.
1. Select your INSTEON Controller from the list below and follow the method shown to put it into
Unlinking Mode.
A. A SwitchLinc V2 Dimmer – Follow the instructions in the section Unlinking a
Controlled INSTEON Device from KeypadLinc Dimmer, above. (Briefly, press and
hold the SwitchLinc Dimmer’s Paddle Top for 10 seconds twice.)
B. ControLinc
™ V2 Tabletop Controller – Press and hold the OFF Button of the
ON/OFF Button Pair you used for controlling KeypadLinc Dimmer for 10 seconds. To
confirm that it is in Unlinking Mode, ControLinc V2’s Status LED will begin blinking.
C. KeypadLinc
™ V2 – Press and hold for 10 seconds the button you used for controlling
KeypadLinc Dimmer, then press and hold the same button for 10 seconds again. To
confirm that it is in Unlinking Mode, KeypadLinc V2 will flash the light that it is wired to
once and begin blinking the button that you pushed.
D. Other INSTEON Controllers – See the INSTEON Controller’s User’s Guide.
2. Press and hold the On Button for 10 seconds on the KeypadLinc
Dimmer that is being controlled. To confirm unlinking, the
KeypadLinc Dimmer will blink its LED and also the light that it is
wired to. Depending on the INSTEON Controller, you have about 4
minutes to perform this step before Unlinking Mode times out
automatically.
Page 19 of 38