Samsung SPH-20W/P - Manual (Page 5)

6 OUTDOOR DOME HOUSINGS 7 OUTDOOR DOME HOUSINGS
8-32 Security
fastener
Place for
connectors
Figure 3
1. Open the housing by loosening the (3) captive screws located on the housing
ring next to the lower clear dome. Be careful not to back these all the way out.
Twist the dome and ring assembly slightly in a counterclockwise motion to
remove (Figure 2).
2. Install the pan/tilt unit quick-release bracket. It is recom- mended that this be
done before installing the housing.
3. It is recommended that the unitized camera be installed at this time. Connect
to the quick-release bracket and secure per manufacturer directions.
4. Clean the inside of the dome, with the text-wipe provided. Reattach the
housing dome and secure the (3) captive screws.
Do not overtighten the screws. Tighten only to the point at which the gap
between the ring and the housing top closes.
Figure 2
Loosen screws only,
do not remove
Remove dome by
twisting counter-
clockwise
INSTALLING THE HOUSING ASSEMBLY
FOR WALL MOUNT VERSIONS
1. A wall mount bracket comes standard with this unit, and a template is
included to use as a guide for mounting the bracket to a wall. Choose the
desired location for installation and mark the drill holes using the template.
Screw (2) bolts (not provided) about 3/4 of the way into the (2) top holes. Run
approximately 8" of wiring out of the wall.
2. Open the access door on the bottom of the wall mount by loosening the screw
nearest the mounting plate (Figure 3).
3. Slip the housing onto the top (2) bolts and pull the wires from the wall through
the rectangular hole in the wall mount bracket. Screw bolts and washers
through the bottom (2) holes and secure. Remove the top (2) bolts, add
washers, and reattach, tightening completely.
4. Attach the wires from the wall to the connector provided, using the wiring
color code chart as a guide.
5. Once all wiring connections are made, place the wires inside the wall mount
bracket and close the access door. Secure with the screw removed earlier.
6. Clean the outside of the dome with the text wipe provided.
It is recommended that this be done before installing the housing.
INSTALLING QUICK RELEASE BRACKET AND
UNITIZED CAMERA ASSEMBLY