Sennheiser SR 2050 IEM - Manual (Page 14)

Using the transmitter
13
Using the transmitter
To establish a transmission link, proceed as follows:
1. Switch the transmitter on (see below).
2. Switch the EK 2000 IEM receiver on (see the instruction manual of the receiver).
The transmission link is established.
If you cannot establish a transmission link between transmitter and receiver:
̈
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
̈
If necessary, read the chapter “If a problem occurs ...” on page 24.
Switching the transmitter on/off
To switch the transmitter on (online operation):
To switch the transmitter to standby mode :
̈
If necessary, deactivate the lock mode (see page 14)
To switch the transmitter on and to deactivate the RF signal on switch-on (offline operation):
To completely switch the transmitter off :
̈
Disconnect the transmitter from the mains by unplugging the mains plug from the wall
socket.
The backlighting of the
STANDBY button º goes off.
It is vital to observe the notes on frequency selection on page 22.
0**
º
̈
Briefly press the STANDBY button
º
.
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon
ቦ
is displayed.
̈
Keep the STANDBY button
º
pressed until “ OFF ” appears on the display panel.
The display panel switches off.
When in the operating menu, pressing the STANDBY button
º
will cancel your entry
(ESC function) and return you to the standard display.
The STANDBY button
º
is backlit in red both during operation and in standby mode.
̈
Press the STANDBY button
º
until “ RF Mute On? ” appears on the display panel.
̈
Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit an
RF signal. The transmission icon
ቦ
is not displayed.
Standard -18dB
MHz
PEAK
-10
0
-20
-30
-40
PEAK
-10
0
-20
-30
-40
AF II AF I
**2000**
552.300
B.Ch: 5.14
EQ
ቦ