Sennheiser System 2013 PLL - Manual (Page 26)

3.5 mm dia. Stereo jack
High-level output (2 x 0.7 V / 32
Ω
)
2.5 mm dia. Stereo jack
Low-level output (2 x 3 mV / 2 k
Ω
)
2.8
Characteristics
• Up to 16 PLL-controlled frequencies
• Highly visible indicator lamp for all important functions
• Child-proof due to lockable cover of adjustment elements
• Integrated automatic fade-in feature
• Built-in microphone. The receiver becomes a hearing aid
if required. - even without additional accessories -
Connection possibilities on receiver EK 2013 PLL
There are two stereo cinch jacks on the left side of the unit: a large jack with 3.5 mm dia.
and a small jack with 2.5 mm dia.
Only stereo cinch plugs may be inserted into the two jacks! Mono plugs lead to
malfunction or short circuit. Mono headphones must be equipped with stereo cinch plugs.
Integrated antenna
In both jacks the inserted cable is simultaneously used as an antenna. Only use original
Sennheiser cables!
Operation on hearing aid with audio input
The small jack (2.5 mm dia.) supplies the output signal for a hearing aid with an audio
input. Hearing aid dealers carry suitable connection cables.
(also see „CABLES“)
Operation on hearing aid without audio input
The „Tele-Loop“ ETZ 1011 or the Induction Disc EZI 120 for hearing aids without an
audio input is connected to the large jack (3.5 mm dia.).
Operation with headphones
Stereo headphones (impedance > 32
Ω
) are connected to the large jack.
Receiver EK 2013 PLL