Sony MVS8000SF-C - Manual (Page 18)

1-10
MVS-8000SF
1-5. Rack Mounting
2. Loosen the screws on the rear of the right and left
adapters and adjust the length of the adapter according
to the depth of the rack.
(The illustration below shows the left adapter.)
n
Maximum depth of adapter : 750 mm
Minimum depth of adapter : 595 mm
3. Attach the right and left adapters to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adapter.)
4. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adapter
completely (the screws that were loosened in step 2).
5. Remove the front panel of the equipment.
(Refer to Section 1-4-1.)
B4 x 6
B4 x 6
Portion of
the rail
Adapter
B4 x 10
B4 x 10
31.75
31.75
1U
4U
8U
Unit : mm
6. Align the groove of the rack tool at the side of the
equipment with the rail, and slide the equipment to the
rear.
n
The rack tools are hooked on the rails as shown below.
7. Fix the rack angle in the rack using the specified
screws.
8. Attach the front panel to the equipment.
(Refer to Section 1-4-1.)
Rack tool Rack tool
Rail Rail
B5 x 12
B5 x 12