Sony MVS8000SF-C - Manual (Page 63)

1-55
MVS-8000SF
1-8. Checks on Completion of Installation
TP401 (C-7) : CPU half clock signal check
terminal
Use this terminal to check the CPU half clock signal.
TP402 (B-7) : CPU clock signal check terminal
Use this terminal to check the CPU clock signal.
TP900 (M-10), TP1200 (K-10) : ERR check terminal
SDI signal error measuring terminal.
TP201 (L-13) : VD (vertical sync) signal check
terminal
Use this terminal to check the VD signal that is used in this
circuit board.
TP202 (L-12) : CKX (control timing) signal check
terminal
Use this terminal to check the CKX signal that is used in
this circuit board.
TP203 (M-13) : HD (horizontal sync) signal check
terminal
Use this terminal to check the HD signal that is used in this
circuit board.
TP204 (M-12) : FLOE (field odd even) signal check
terminal
Use this terminal to check the FLOE signal that is used in
this circuit board.
TP205 (L-12) : VCLK (clock for video signal)
signal check terminal
Use this terminal to check the clock for video signal.
<LED on the CPU DR module> (C11)
Refer to < LED on the CPU DR module > in “1. CA-44
Board”.
<Switch on the CPU DR module> (C11)
Refer to < Switch on the CPU DR module > in “1. CA-44
Board”.
<Switch>
S2001 (A-5) : JTAG switch
Used only for production in the assembly factory. Set this
switch to ON only when writing program in the JTAG
device with ISP.
S101 (A-8) : CC-CPU reset switch
Pressing this switch initializes the CPU on the CC-90
board.
S400 (A-8) : Monitor reset switch
The reset switch that is used to reset the monitor during
maintenance through the terminal.
<Connector>
CN2001 (A-6) : ISP common connector
Used only for production in the assembly factory. Used for
program writing into the JTAG device with ISP.
CN401 (A-7) : Terminal pin
This pin is connected to the control terminal and used
during maintenance.
Conforms to RS-232C.
<TEST terminal>
E101 (A-5), E103 (D-5), E104 (L-12), E105 (N-8),
E106 (B-8), E107 (B-13), E108 (J-9) : GND terminal
Use this terminal as the earth point for measuring the
respective check terminals.
TP101 (A-3) : + + + + +12 V check terminal
+12 V measuring terminal.
TP9501 (A-3) : + + + + +3.3 V check terminal
+3.3 V measuring terminal.
TP9001 (A-4) : + + + + +1.8 V-1 check terminal
+1.8 V-1 measuring terminal.
TP9301 (A-4) : + + + + +1.8 V-2 check terminal
+1.8 V-2 measuring terminal.
TP400 (C-8) : System clock signal check terminal
Use this terminal to check the system clock signal supplied
from CPU module.