Sony MVS8000SF-C - Manual (Page 45)

1-37
MVS-8000SF
TP3309 (H-5) : CK2 signal check terminal
Uses this terminal when checking the clock signal for video.
TP3310 (G-11) : CK3 signal check terminal
Uses this terminal when checking the clock signal for video.
TP3400 (A-5) : + + + + +1.8 V check terminal
+1.8 V measuring terminal.
TP3500 (A-4) : + + + + +2.5 V check terminal
+2.5 V measuring terminal.
TP3600 (A-4) : + + + + +3.3 V check terminal
+3.3 V measuring terminal.
TP3700 (A-4) : + + + + +12 V check terminal
+12 V measuring terminal.
<LED on the CPU DK module> (C-10)
Refer to < LED on the CPU DR module > in “1. CA-44
Board”.
<Switch on the CPU DK module> (C-10)
Refer to < Switch on the CPU DR module > in “1. CA-44
Board”.
S2700 (A-7) : JTAG switch
Used only for production in the assembly factory. Set this
switch to ON only when writing program in the JTAG
device with ISP.
<Connector>
CN2301 (A-6) : TERMINAL pin
This pin is connected to the CPU control terminal and used
during maintenance. Conforms to RS-232C.
CN2700 (A-6) : ISP common connector
Used only for production in the assembly factory. Used for
program writing into the JTAG device with ISP.
<TEST terminal>
E2300 (B-8), E3404 (P-13), E3407 (N-8), E3408 (L-11),
E3410 (G-13), E3411 (P-1), E3412 (N-5), E3414 (L-2)
E3417 (K-5), E3419 (E-7), E3421 (B-13), E3425 (E-3),
E3426 (D-5), E3427 (K-12), E3429 (B-5) : GND
terminal
Use this terminal as the earth point for measuring the
respective check terminals.
TP1300 (G-13), TP1400 (E-13) : ERR check
terminal
SDI signal error measuring terminal.
TP2301 (A-9) : CPU CK (CPU clock) signal check
terminal
Used to check the CPU clock.
TP3300 (L-13) : FLOE (field odd even) signal
check terminal
FLOE signal measuring terminal.
TP3301 (M-13) : HD (horizontal sync) signal check
terminal
HD signal measuring terminal.
TP3302 (M-13) : CKX (control timing) signal check
terminal
CKX signal measuring terminal.
TP3303 (M-13) : VD (vertical sync) signal check
terminal
VD signal measuring terminal.
TP3308 (L-12) : CK1 (clock for video signal) signal
Uses this terminal when checking the clock signal for video.
1-8. Checks on Completion of Installation