SECO-LARM USA Central Receiver SK-910RC4Q - Manual (Page 5)

ENFORCER SK-910RC4Q Central Receiver
SECO-LARM U.S.A., Inc. 5
Programming Each Channel Output:
1. Each channel output can be separately programmed for one of four different modes:
Timed Output: When the channel receives a signal, the relay will turn ON for 1~60 seconds,
depending on the output time set.
Note: The timer, once set, is the same length for all outputs programmed for Timed Output.
(See page 6 for timer programming.)
Toggle Output: When the channel receives a signal, the relay will turn ON and remain
activated until a second signal is received.
Latch Output: When the channel receives a signal, the relay will turn ON. Turn the relay OFF by
pressing that channel’s programming button on the Central Receiver unit.
Validity Output: When the channel receives a signal, the relay will turn ON for as long as a signal
is being received.
2. To enter programming mode, press the button marked Mode on the top of the unit. Each
channel’s red LED will flash a number of times to show the current output mode that it is in:
3. To change modes, press the desired channel’s transmitter programming button. Each press
moves to the next mode in the sequence shown in the diagram below. After changing modes,
count the number of times the channel LED flashes to verify the channel is in the correct mode.
4. When finished, press Mode again to end programming.
# of Flashes Output Mode
1 Timed Output
2 Toggle Output
# of Flashes Output Mode
3 Latch Output
4 Validity Output
Example 1: If the present mode is Timed Output, and
the desired mode is Latch Output, press the
channel’s programming button 2 times.
Example 2: If the present mode is Validity Output and
the desired mode is Latch Output, press the
channel’s programming button 3 times.
Toggle Output
(2 flashes)
Validity Output
(4 flashes)
Timed Output
(1 flash)
Latch Output
(3 flashes)
Programming Button Functions (Per Channel)
Learn mode Press and hold the button for 3 seconds or more to enter Learn mode.
Clear memory Press and hold the button for 3 seconds or more. When LED starts flashing, press
and hold again for 3 seconds to delete all learned codes. LED will flash twice.
Reset Latch Output If channel is set to Latch Output, press to turn relay off after it has been triggered.
Memory display Press momentarily. The Channel LED will flash a number of times corresponding to
the number of codes stored.
LED Indicator Functions (Per Channel)
Steady ON Receiving signal from transmitter OR indicates code has already been learned
during code learning.
Fast flash In either code learning OR memory display OR channel output programming mode.
One flash A transmitter’s code was learned OR channel relay is in Timed output mode.
Two flashes All learned codes were deleted OR channel relay is in Toggle output mode.
Three flashes Channel relay is in Latch output mode.
Four flashes Channel relay is in Validity output mode.
0~15 flashes During normal operation, press the programming button to display the number of
codes stored. 1 flash = 1 code stored.