SECO-LARM USA Central Receiver SK-910RC4Q - Manual (Page 7)

ENFORCER SK-910RC4Q Central Receiver
SECO-LARM U.S.A., Inc. 7
Setting the Power LED:
The power LED can be set to Bright, Dim, or OFF using the power LED jumper.
1. Locate the jumper on the PCB as shown below.
2. Place the jumper on the middle and right pins for Dim, and on the middle and left pins for Bright.
3. Remove the jumper or place on the left or right pin only to set the power LED to OFF.
Sample Applications:
1. A photobeam sensor installed on a driveway (E-960-D90Q or similar) is connected to an
RF wired transmitter (SK-919TDWS-BU or similar). When the photobeam sensor is
triggered, the transmitter sends a signal to the SK-910RC4Q Central Receiver.
2. Inside, an alarm, lamp, or other signaling device is connected to the channel’s relay output.
When the intruder triggers the photobeam sensor, an alarm is triggered or the light turns on.
3. Alternatively, a DVR (DR-1 series or similar) can be connected to an RF wired transmitter.
When an event (such as motion detection) occurs on the DVR, the transmitter sends a signal
to the SK-910RC4Q Central Receiver, alerting the user and activating the channel relay.
4. In addition to connecting a signaling device to the channel relay output, an auxiliary device
such as an LED strobe light (SL-1301 series or similar), can be powered by the SK-910RC4Q
Central Receiver when a channel is activated.
Power LED jumper settings
Bright Dim
Jumper
PCB
Off
Outside driveway
Indoor location
Recording station
E-960-D90Q
SK-919TDWS-BU
Lamp
SL-1301-BAQ
SK-919TDWS-BU
DR-116Q
SK-910RC4Q