Sony CMT-C7NT - Manual (Page 24)

24
Turn on the Level Synchro
Recording function
Note
You cannot mark track numbers automatically if the
sound source to be recorded is noisy (e.g., tapes or
radio programs).
1
Press FUNCTION repeatedly until “MD”
appears in the display.
2 Press MENU/NO on the remote.
3
Press . or > repeatedly until
“Setup?” appears in the display, and then
press ENTER/YES on the remote.
4
Press . or > repeatedly until “T.Mark
Off” (or “T.Mark LSync”) appears, and then
press ENTER/YES on the remote.
5
Press . or > repeatedly to select the
setting, and then press ENTER/YES on the
remote.
To Select
Recording tips (continued)
T.Mark LSync
(factory setting)
Turn off the Level Synchro
Recording function T.Mark Off
When you set the Level Synchro Recording
function, “L-SYNC” lights up.
6
Press MENU/NO on the remote.
To continue and record, follow the
procedures described on the various
recording pages.
Marking track numbers
• Automatically during recording
Track numbers are automatically marked as on
the original source during recording from this
system’s CD player or components connected
to the DIGITAL OPTICAL IN jack. However,
track numbers may not be marked for some
tracks (see page 56). Use the Level Synchro
Recording function to automatically mark track
numbers during recording from this system’s
tuner or components connected to the TAPE IN
jack.
• At any point during recording
You can mark track numbers during manual
recording of any source (see page 25).
• After recording
Use the Divide Function (see page 37).
Marking track numbers
automatically during recording
— Level-Synchro Recording
The Level-Synchro Recording function is
factory-set to on, so the track numbers are
automatically marked. If “L-SYNC” does not
appear during recording, turn on the Level-
Synchro Recording as follows. Track numbers
are automatically marked when the input signal
is continuously below a certain level for more
than 2 seconds and then exceeds that level.