Sunrise Medical User Manual - Manual (Page 11)

11
Step 3 – Connect to power supply.
Be sure to use the original sunrise surf & talk box power cord. Other power cords may damage or destroy the de-
vice. If other power cords are used, sunrise does not assume responsibility for damages. First insert the small con-
nector in the upper round slot in the sunrise surf & talk box, and then insert the larger connector in the power outlet.
The device generally takes between 60–90 seconds to start up. The “Welcome” picture from the sunrise surf & talk
box will appear, along with the message “Please wait...”.
After the warm-up phase, you will see the message “Network search”. If a “Connection failure” message appears
on the display, unplug the power plug, wait 20 seconds, and plug the power cord back in. Repeat this process until
you are requested to enter a PIN number. If this has already occurred, the start screen will appear on the display.
The connection bars on the right edge of the display show the quality of the connection.
Note: Please note that the type of connection is shown at the bottom of the display, “WLAN” on the left or
“LAN” in the middle. The available network is shown on the bottom right ((U=UMTS, E=EDGE, G=GPRS).
Step 4a – Connect your PC/laptop to the sunrise surf & talk box.
There are two ways of connecting the sunrise surf & talk box to your PC or laptop: either using WLAN (wireless) or
with the enclosed network cable (LAN).
Note: You need not shut down your computer in order to attach the network cable.
Step 4b – Attach telephone.
If desired, you can use the telephone in “stand alone” function, for example if you do not have a computer. Before
you can use the telephone functions of the sunrise surf & talk box, you must activate the SIM card for sunrise surf
& talk by entering the PIN. The PIN is saved in the sunrise surf & talk box. If you switch the sunrise surf & talk SIM
card, you have to enter the PIN for the new sunrise surf & talk SIM card.After you connect a telephone to the sun-
rise surf & talk box and enter the PIN, you can make and receive calls immediately.
1. Pick up your receiver.
The SIM card card for sunrise surf & talk is not yet activated. On the sunrise surf & talk box display, the follow-
ing message appears: “Please enter PIN”. You will hear the dial tone, and an additional signal tone.
2. Press the button, enter your PIN and confi rm by pressing the button.
If the PIN you entered is correct, you will hear a confi rmation tone.
If the PIN you entered is incorrect, you will hear a warning tone and the following message will appear on the
display: “Incorrect PIN. X attempts remaining”.
3. Make a call or put the receiver back down.
sunrise surf & talk First steps