Schwinn NAUTILUS A10 - Manual (Page 15)

Check data cable integrity All wires in cable should be intact. If any are cut or
crimped, replace cable.
Check data cable connections/orientation Insure cable is connected securely and oriented
properly. Small latch on connector should line up and
snap into place.
Reset Machine (if equipped with reset button) Unplug unit from electrical outlet for 3 minutes.
Reconnect to outlet. After Console powers up, press
"reset".
Fan (if equipped) will not turn on or will not turn off
If bike has batteries, check Battery Indicator on console
or check batteries.
If the battery level shows low or no power, replace
the batteries.
Fan (if equipped) will not turn on, but Console operates Check for blockage of fan Turn power off (remove batteries or unplug power
adapter). Remove material from fan. If necessary,
detach the Console to help with removal. Replace the
Console if unable to remove blockage.
Check leveler adjustment Leveling feet may be turned to level bike. Unit rocks/does not sit level
Check surface under unit Adjustment may not be able to compensate for
extremely uneven surfaces. Move bike to level area.
Check pedal to crank connection Pedal should be tightened securely to crank. Insure
connection is not cross-threaded.
Pedals loose/unit difficult to pedal
Check crank to axle connection Crank should be tightened securely to axle. Be sure
cranks are connected at 180 degrees from each other.
Check locking pin Insure adjustment pin is locked into one of the seat
post adjustment holes.
Seat post movement
Check adjustment knob Insure knob is securely tightened.
15 15 15