Sony Trinitron KD-32DX40U - Manual (Page 8)

Getting Started
6 Getting Started
5. Automatically tuning the TV
1. When you switch on the TV for the first time a menu appears on the
screen asking you to check if the picture is slanted. (Sometimes the
Earth’s natural magnetism can cause the screen to look tilted.)
2. The autotune prompt screen appears. Press the OK button to select
‘Yes’. The autotune procedure begins.
The Digital autotune display appears on screen and the search and
store procedure begins. All the available Digital channels will now be
captured and stored. As this may take some time, a message is
included in the display to inform you of the tuning progress.
When Digital tuning is complete, the analogue display appears
automatically and the search and store procedure for the analogue
channels begins.
If no Digital and no analogue channels are found, a menu appears
asking you to confirm your aerial is connected. After checking the
aerial has been connected press OK to begin the autotune
procedure again.
Once all Digital and analogue channels have been captured and
stored, the TV returns to normal operation and displays the Digital
channel captured on channel number 1.
Note: If no Digital channels are captured, the analogue channel that is stored
on channel number 1 is displayed.
3. To view programmes, press the PROG+/- buttons or the numbered
buttons.
a) If no correction is required, press the V or v buttons on the
remote control to highlight ‘Not necessary’ and press the OK
button.
b) If some correction is required, press the V or v buttons on the
remote control to highlight ‘Adjust now’, then press the OK
button. Correct the slant by pressing the
V or v buttons then
press the OK button to store.
Not necessary
If picture slants, please
adjust picture rotation.
Adjust now
OK OK
Auto Tuning
Programme: 02
Channel : C29
Completed 16%
Checking the picture tilt.
The autotune prompt screen.
Tuning the Digital channels.
Tuning the analogue channels.
VIDEO / TV /
DIGITAL
O K
1 2 3
6 5 4
7 8 9
0
6. Watching a pre-recorded video tape
1. You should have inserted a pre-recorded video tape during the
‘Connecting an aerial and a VCR’ section. To view the video picture
press ‘PLAY’ on the VCR. The TV automatically displays the video
picture (providing that you have used a fully wired 21 pin scart lead
to connect your VCR to the TV).
If the video picture does not automatically appear, press the /
button on the remote control repeatedly until the video picture is
displayed on the TV screen.
2. Press the DIGITAL/ button on the remote control to return to
normal TV mode.
Note: Alternatively, with the TV in analogue mode, press the PROG +/- buttons
on the remote control until the picture from the pre-recorded video tape
appears on the TV screen.
If you wish to move your video channel to a different channel number,
refer to the ‘Programme Sorting’ feature in ‘The Set Up menu’ section of
this instruction manual.
VIDEO / TV /
DIGITAL
DX40 Pages 1-10.fm Page 6 Wednesday, August 22, 2001 12:06 PM