Siemens AX75 - Manual (Page 6)

right page (5) of AX75_Pegasus, short, 140mm, en, A31008-H2850-A1-1-7619 (18.04.2005, 10:38)
© Sieme
ns
A
G
200
4,
C:
\S
iemen
s\
D
TP-S
atz\
Pro
dukte
\A
X75_
Pega
su
s_
1\
out
-
5 Getting started
VA
R
Langu
age:
en;
VAR issue da
te:
050
307
Getting started
Using the SIM card/battery
Your phone's display is delivered with a
protective film. Remove this film before get-
ting started . The service provider supplies
you with a SIM card on which all the im-
portant data for your account is stored. If
the SIM card is credit card-sized, snap out
the smaller segment and trim any rough
edges.
Press depression
1
to remove the
cover downwards in the direction of the
arrow
2
.
Insert SIM card
3
and push it fully into
the locating slot (make sure the angled
corner is in the correct position
4
).
To remove the SIM card push the card
here
5
.
Insert the battery sideways into the phone
6
, then press downwards
7
until it
engages.
To remove, press the retaining tab
8
then lift the battery out.
Place cover on phone and push to the up-
per edge, until it clicks into place
9
.
Always switch off phone before removing
the battery!
Only 3V and 1.8V SIM cards are support-
ed. Please contact your service provider if
you have an older card.
Charge battery
The battery is not fully charged when de-
livered. Plug charger cable into the bot-
tom of the phone, plug power supply unit
into a mains power socket and charge for
at least two hours. The power supply unit
heats up when used for long periods. This
is normal and not dangerous.
1
2
3
4
5
7
8
6
9