Switch on/off, pin, Emergency number (sos), General instructions – Siemens AX75 User Manual
Page 7: A d g, Switch on/off, Enter pin, Signal strength, User guide
© Sieme
ns
A
G
200
4, C:
\S
iemen
s\
D
TP-S
atz\
Pro
dukte
\A
X75_
Pega
su
s_
1\o
ut
-
left page (6)
of AX75_Pegasus, short, 140mm, en, A31008-H2850-A1-1-7619 (18.04.2005, 10:38)
Switch on/off, PIN
6
VA
R
Langu
age:
en;
VAR issue da
te:
050
307
When charging is in progress
h
is
displayed.
Charging time
An empty battery is fully charged after
about 2 hours. Charging is only possible
within a temperature range of
+5 °C to +40 °C. If the temperature ris-
es/falls 5 °C above/below this, the charge
symbol flashes a warning. The mains volt-
age specified on the power supply unit
must not be exceeded (Operating time,
p. 22).
Charge icon not visible
If the battery has been discharged fully
the charge icon is not immediately visible
when the power supply unit is plugged
in. It will appear after up to two hours. In
this case the battery is fully charged after
3-4 hours.
Only use the power supply unit provided!
Display while in service
Charge level display during operation
(empty - full):
a d g
.
A beep sounds when the battery is nearly
empty. The charge level of the battery is
only displayed correctly after an uninter-
rupted charging/discharging cycle. You
should therefore not remove the battery un-
necessarily
and where possible not termi-
nate the charging process early
.
Switch on/off, PIN
Switch on/off
Press and hold the On/Off/End key
B
to
switch on or off.
Enter PIN
The SIM card can be protected with a
4- to 8-digit PIN.
Enter the PIN using the number keys. The
characters
****
appear to ensure no-
body can read your PIN on the display.
Correct errors with
§Clear§
.
Confirm your input with
§OK§
. Logging on
to the network will take a few seconds.
Emergency number (SOS)
Only to be used in real emergencies!
By pressing the soft key
§SOS§
you can
make an emergency call on any network
without
a SIM card and without entering a
PIN (not available in all countries).
Signal strength
_
Strong reception signal.
^
A weak signal reduces the call
quality and may lead to loss
of the connection. Change your
location.
General instructions
User guide
The following symbols are used to explain
operation:
J
Enter numbers or letters.
B
On/Off/End key.
A
Call key.
D
Press navigation key on the side
indicated
§Menu§
Displays a soft-key function.
L
Function depends on the service
provider, special registration
may be necessary.