Superior SSDVT-3328CNM - Manual (Page 7)

7
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
WarninG
the size and position of the log set
was engineered to give the appli-
ance a safe, reliable and attrac-
tive flame pattern. any attempt
to use a different log set in the
fireplace will void the warranty
and will result in incomplete
combustion, sooting, and poor
flame quality.
reFerence
Firebox accessories / parts
cat. no. Model no. description
88L53 FGe Bag of Glowing embers
( oz. rockwool)
80L42 FdVs
Bag of decorative
Volcanic stone
Table 8
Bag of Glowing
Embers (rockwool)
Separate into Quarter
Size (separate) Pieces
WarninG
do not attempt to install the logs
until the appliance installation
has been completed, the gas line
connected and tested for leaks
and the initial burner operation
has been checked out.
Figure 8 - Glowing Embers
WarninG
this appliance is not designed
to burn wood. any attempt to
do so could cause irreparable
damage to appliance and prove
hazardous to your safety.
WarninG
Logs get very hot and will remain
hot up to one hour after gas
supply is turned off. Handle
only when logs are cool. turn
off all electricity to the appli-
ance before you install grate
and logs.
instaLL LoGs, VoLcanic stone and
GLoWinG eMBers
Carefully position the ceramic fiber logs and
twigs over the burner according to the following
steps, while referring to Figure 7.
. Set the rear log on the raised log support
brackets at the rear of the firebox, fitting
the slots in the logs over the brackets.
2. Position the front log with the pins for the
two side twigs in the up position, and the
two vertical burner tabs recessed into the
two notches at the rear of the log. Check
for recessing of brackets into log notches
(by touch) to verify correct log placement.
3. Insert the alignment hole of the left twig over
the front log's left pin. Rotate the left twig
until it just touches the edge of the ember
bracket.
4. Insert the alignment hole of the right twig
over the front log's right pin. Rotate the
right twig until it almost touches the front
panel glass.
Note: Proper twig placement is critical in the
gaps between the flame peaks and should be
positioned so that at no time they impinge
the flames.
Glowing ember/Volcanic stone placement
Remove the replacement rockwool (Glowing
Embers) from the packaging and tear into
quarter size pieces (see Figure 8 ).
Spread rockwool (quarter-sized pieces) on and
along the length of the burner screen. Do not
use more than is necessary. To many quarter-
sized pieces on the front burner section will
cause poor combustion.
When properly positioned, the rockwool will
unevenly cover approximately 85% of the
burner screen, with no appreciable gaps or
openings.
To install Decorative Volcanic Stone, mound up
a portion of the volcanic stone in front of the
burner in a pattern to suite individual taste.
Figure 7 - Log Set (Shown With Optional Log Rack)