Salton, Inc BL-1051 - Manual (Page 5)

HELPFUL HINTS
• Allow hot liquids to cool to a lukewarm temperature before processing.
• Always place your hand on top of the Safety Handle when operating.
• While the motor is running, ingredients can be added through the Filler
Cap opening in the center of the Blender Lid.
• DO NOT operate the Blender for more than 90 seconds when processing
dry ingredients.
• DO NOT run the Blender when empty.
CARE AND CLEANING
1. Unplug from wall outlet.
2. Remove Blender Jar from Blender Base. NOTE: For safety purposes the Cutting
Blade Assembly is designed so it cannot be removed from the Blender Jar.
3. Empty the Blender Jar completely. Rinse the inside of the Blender Jar with
water to dislodge any food that may be stuck to the Cutting Blades.
4. Add a small amount of dishwashing liquid into the Blender Jar and fill
halfway with water.
5. Put the Blender Jar back on the Blender Base, raise Safety Locking Handle
and blend on ‘LOW’ speed for 30 seconds.
6. Remove Blender Jar from Blender Base, rinse Blender Jar with clean water
and then repeat with clean running water only. Air dry Blender Jar thoroughly
and ensure that the inside of the Blender Jar is completely dry before storing.
IMPORTANT: Use extreme caution when cleaning Blender Jar by hand as the
blades are very sharp.
7. Wash the Lid and Filler Cap in warm soapy water. Rinse, air dry thoroughly
and reassemble.
8. Wipe the Blender Base with a damp cloth. If necessary, you can use a little
mild detergent. DO NOT IMMERSE IN WATER OR ANY OTHER LIQUID.
DO NOT use harsh detergents or abrasive cleaners on any part of the appliance.
5
SAL7-585 Booklet Blender Salton BL-1051 _EN VF.qxd 03/08/07 17:19 Page 5