Placing the handset in the charging cradle – Siemens Gigaset SL565 User Manual
Page 8
7
First steps
Gigaset SL565 / GBR PTT / A31008-M1715-L111-2-7619 / starting.fm / 11.7.07
Closing the battery cover
¤
Align the notches on the side of the
battery pack with the lugs on the inside
of the casing.
¤
Then close the cover so that it clicks
into place.
Attaching belt clip
There are notches for attaching the belt
clip on the side of the handset at approxi-
mately the same height as the display.
¤
Press the belt clip onto the back of the
handset so that the lugs on the belt clip
click into the notches.
Opening the battery cover
¤
Remove the belt clip if the phone is
mounted.
¤
Pick the device up with the keypad
facing the palm of your hand.
¤
Insert your forefinger into the notches
on the lower edge.
¤
Gently lift the cover up out of the not-
ches.
Placing the handset in the charging
cradle
¤
Plug the charging cradle mains adapter
into a mains power socket.
¤
Place the handset in the charger with
the display facing forward.
The handset is already registered with the
base station at the factory.
INT 1
appears in
the display. You do not have to re-register.
If, however, you have to register your
handset with the base station, please see
Leave the handset in the charging cradle
to charge the battery pack.
For questions and problems see page 56.
Note
You can change the name of the handset
Please note:
– If the handset has switched itself off
because the battery pack is flat and is then
placed in the charging cradle, it will switch
itself on automatically.
– The handset must only be placed in the
designated charging cradle.