Smeg LS19-7 - Manual (Page 13)

User instructions
3.3 Washing programs
The dishwasher is equipped with a control panel and an INFORMATION
DISPLAY (8), described in chapter "1. Description of the controls", from
which it is possible to carry out all the power switch-on, switch-off and
programming operations.
Before starting a washing program make sure that:
•
The water supply tap is open.
•
The correct amount of detergent has been added to the
dispenser.
•
The baskets have been correctly loaded.
•
The spray arms are able to rotate freely and without
obstruction.
•
The dishwasher door is securely closed.
CANCELLING THE CURRENT PROGRAM
To annul the current program, press the START/PAUSE button (3) for a
few seconds, until the beep of confirmation is heard.
At this point, to end the program, press the HALF LOAD (5) and
START/PAUSE (3) buttons simultaneously.
"P0" appears on the INFORMATION DISPLAY (8) and the dishwasher
will automatically switch to the end of the cycle, displaying the word
"End" when done.
CHANGING THE PROGRAM
To change the program, press and hold down the START/PAUSE button
(3) for a few seconds, then select the new program as described
previously in the instructions; press the START/PAUSE button (3) again,
holding it down for a few seconds.
12