Smeg LS19-7 - Manual (Page 17)

User instructions
STARTING THE DISHWASHER
After correctly carrying out all the preceding operations, to start the
dishwasher simply press the START/PAUSE button (3) for a few
seconds, until the start cycle acoustic device sounds.
The INFORMATION DISPLAY (8) will show the duration of the program
in minutes. The duration time is only approximate, because it depends
on the washing conditions (quantity of dishes, water temperature, etc.),
and is also continually updated as the washing program progresses.
The INFORMATION DISPLAY (8) shows the estimated duration of the
washing program.
If it is necessary to open dishwasher door during the washing cycle,
there will be a 1-minute delay before the program can be resumed.
After correctly closing the door, press the START/PAUSE button (3)
again. This operation may negatively affective the progress of the
washing cycle.
END OF CYCLE
The beeper sounds briefly and the word "End" appears on the
INFORMATION DISPLAY (8) to indicate the end of the program.
Before setting a new washing program, the door must first be opened,
then reclosed, or the START/PAUSE button (3) pressed to “reset” the
display and stop the flashing.
To switch off the dishwasher turn the ON/OFF switch (2) anticlockwise
back to the vertical position.
REMOVING THE DISHES
At the end of the washing program, wait at least 20 minutes before
removing the dishes, to allow them to cool down. To prevent any water
droplets on the upper basket from falling on the dishes in the lower
basket, it is advisable to unload the lower basket first, and then the
upper basket.
16