Samsung CS29K10MQ - Manual (Page 37)

37
A degaussing coil is mounted around the picture tube, so you do not normally need to degauss
the television manually.
If you move the television to a different position and color patches appear on the screen, you must:
u Switch the television off by pressing the “ ” (ON/OFF) button on the front panel
u Unplug the television from the wall socket
u Leave the television power-off (stand-by) for about 30 minutes so that the automatic
degauss function can be activated, and then press the POWER
button on the
remote control.
* *
If your television will be left unattended, press the “ ” (ON/OFF) button to turn your
television off.
Automatic Degaussing to Remove Colour Patches
Wiring the Mains Power Supply Plug (UK Only)
IMPORTANT NOTICE
The mains lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of the fuse is
indicated on the pin face of the plug and, if it requires replacing, a fuse approved to BSI1362 of the same rating must
be used.
Never use the plug with the fuse cover omitted if the cover is detachable. If a replacement fuse cover is required,
it must be of the same colour as the pin face of the plug. Replacement covers are available from your dealer.
lf the fitted plug is not suitable for the power points in your house or, the cable is not long enough to reach a power
point, you should obtain a suitable safety approved extension lead or consult your dealer for assistance.
However, if there is no alternative to cutting off the plug, remove the fuse and then safely dispose of the plug.
DO NOT connect the plug to a mains socket as there is a risk of shock hazard from the bared flexible cord.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code :
BLUE - NEUTRAL - BROWN - LIVE
As these colours may not correspond with the coloured markings identifying the terminals in your plug, proceed as
follows :
The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE or BLACK.
The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWN or RED.
WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE
LETTER E OR, BY THE EARTH SYMBOL , OR COLOURED GREEN OR GREEN AND YELLOW.
ENG
KS3a_Eng_Wide.qxd 10/19/2002 1:03 PM Page 37