SMC Networks Invivo HNC-63-INT - Manual (Page 11)

11
Rev 05
Synergy
MultiConnect
(SMC) The Synergy MultiConnect (SMC) shown here is a
required option to use the HNC-63-INT coil.
IMPORTANT: You must have the SMC device
and Level 8.1.1 or higher software on your
Intera system.
Additionally, Release 8.1.1 software requires a
Synergy MultiConnect patch to enable this coil
to be recognized by your system. Contact your
Philips representative to receive this software
patch. Software releases above 8.1.1 do not
require the patch.
For more information on Synergy MultiConnect, please refer to Intera Release 8
Philips Application Guide/Volume 1 - Basics, Section 3.22.
The Synergy MultiConnect (SMC) is shown here with the HNC coil connector.