Sharpvision XV-Z9000U - Manual (Page 18)

E-18
Setup & Connections
Using the Adjustment Feet
Setting Up the Screen
You can adjust the height of the image by raising the projector with
the foot releases.
1 Press the foot releases and lift the projector to the desired angle.
2 Remove your hands from the foot releases. Once the adjustment
feet have locked in position, release the projector.
3 If the screen is at an angle, the adjusters can be used to adjust
the angle of the image.
Returning the projector to its original position
While holding the projector, press the foot releases and slowly lower
the projector to its original position.
CAUTION
• Do not hold the lens when lifting or lowering the projector.
• When lowering the projector, be careful not to get your fingers caught in the area between the adjustment feet and the
projector.
• The projector is adjustable up to approximately 5° from the standard position.
• When the height of the projector is adjusted, the image may become distorted (keystoned), depending on the relative
positions of the projector and the screen. See page 19 for details on the keystone correction.
The picture can be adjusted within the shift range of the lens by rotating the lens shift dial on the top of the
projector using your finger.
Using the Lens Shift
Lens shift dial
DOWN UP
Projector Projected Image
UP
DOWN
1
3