Sharpvision XV-Z9000U - Manual (Page 5)

E-5
Important
Information
IMPORTANT SAFEGUARDS
Temperature Monitor Function
If the projector starts to overheat due to setup problems or a dirty air filter,
“TEMP.” and “ ” will flash in the lower-left corner of the picture. If the
temperature continues to rise, the lamp will turn off, the TEMPERATURE
WARNING indicator on the projector will flash, and after a 90-second cooling-
off period the power will shut off. Refer to “Lamp/Maintenance Indicators” on
page 45, for details.
• The cooling fan regulates the internal temperature, and its performance is
automatically controlled. The sound of the fan may change during projector
operation due to changes in the fan speed.
Lamp Monitor Function
When the projector is turned on after the lamp has been used for 1,900 hours,
“LAMP” and “ ” will flash in the lower-left corner of the picture to advise you
to replace the lamp. See page 47 for lamp replacement. If the lamp has been
used for 2,000 hours, the projector power will automatically turn off and the
projector will enter standby mode. Refer to “Lamp/Maintenance Indicators”
on page 45, for details.
Using the Terminal Cover
• When ceiling-mounting the projector, attach the terminal cover (supplied)
to hide the connecting cables.
• Use the terminal cover to hide the connecting cables when the projector is
used on a desktop or high mounted.
1 Install the terminal cover using the two attached clips.
2 Attach the terminal cover by aligning with the tab on the projector.
PUSH
1
1
1
2
2